+1-256-642-2600         info@alabamartp.org          Office Location     

Dual Check Safety v7.50 & Newer

Dual Check Safety v7.50 & Newer
Course Description
This course covers the tasks a technician, programmer or engineer would need to accomplish in order to set up and use FANUC s Dual Check Safety (DCS) software. This class is specific to robots with version 7.5 and newer software
Course Objective
Students successfully completing this course will be able to:
  • Set up and Modify DCS General parameters
  • Set up and Modify DCS Position / Speed Check parameters
  • Set up and Modify DCS Safe I/O parameters

In additional to presentations and demonstrations, this course offers a series of exercises for the student to complete. Exercises relate directly to the classroom presentations and are intended to reinforce what the student has learned through actual hands-on experience. This course also includes a pretest and posttest to measure mastery of objectives.

  • Prerequisite

    Completion of an "Operation and Programming" class.

  • Who May Attend?
    Technician, Programmer, Engineer, the person who must set up an R-30iA (software version 7.5 and Newer) or R-30iB FANUC robot controller with DCS software installed
  • Course Length
    16 hours (1.50 CEU)
  • Max Attendee
  • Certification Offered?
  • Pass/Fail Required?

How to reach us?

  • Address :
    6505 U.S. Hwy 31,Tanner, AL 35671
  • Tel : (+1)256  642  2600
  • Email : This email address is being protected from spambots. You need JavaScript enabled to view it.
  • Website : www.alabamartp.org

Get in Touch!

Drop us a note. We're here to serve you.